Ez Extractions
Ez Extractions
Product Features
How To Use
Order
ISO Info
Useful Links
Dictionary
Photo Album
Product Reviews
Contact
About
New Ez Extractions Web Site!
How To Use: Step By Step Instructions
Step by step picture instructions demonstrate how fast and easy it is to use the Cloud 9 Extraction Kit.
1. Load Tube
Fill your tube with your material, you can tamper it down but dont pack it tight!
2. Apply Filter
Place your Ez Extraction Technology Filter on the open, flared end on the tube and secure tightly with either hose clamp or (2) rubber bands.
3. Fill With ISO
Pour/squirt your Isopropyl Alcohol into the 18mm male joint end until the bud is fully saturated (but not submerged).
4. Attach Low Pressure Hand Pump
Connect your low pressure hand pump to the extractor tube via the 18mm male joint and the tubing from the hand pump.
5. Pump
Holding the extactor over a pyrex dish, slowly and steadily pump air into the tube. At this point a small steady stream of ISO solution will be squirting out of your Filter. Pump until no ISO solution comes through. Repeat Steps 3-5.
6. Evaporation (Purge)
Now that you have extracted your oils on to the pyrex dish you need to let it sit out at room tempature in a well vented room or on a low temp heat source until all the isopropyl alcohol has evaporated from the dish and you are just left with a slightly yellow/amber oil on the plate. (evaporation times are subject to change)
7. Scrape
After all the isoproyl alcohol has evaporated its time to put the dish on top of a low tempature heat source, get a razor blade, and start scraping the sticky oils off the plate and ready to enjoy!
^^ How To Video on YouTube